Recent content by chris66

I unplug the automation and I still get the sf code. I have two extra icb panels but did not want to switch it til I was sure I had resolved the other issue. Looking like that is going to have to be replaced but I have ordered a thermistor first to try that first even though resistance test...

I checked wiring and seems good also checked the resistance and also good. and sf code did not happen until I was trying to access it thru the automation. Heater ran off and on for a week off of the controls from heater panel after they left.

Could this incorrect wiring by poool contract cause my sf code or I am just that unlucky to have two problems at once.

Hayward 400 FDN and Omni PL

I have hired a company to install omnilogic pool automatiion. Everyhing works but the heater. They are not returning my phone calls. I think i have identified the problem the pig tail hooked to the remote conection has three wires with labels. 1 spa/hotub combo (for two wire connection )...