Recent content by Chimada

  1. C

    Outside temperature sensor reading higher than actual

    Thanks so much, I checked and it was enabled. Disabled it. Will also move my air sensor to a more shady spot if I can find one. I went out and checked when it was early morning and it read the same. So it is working correct. The solar temp sensor I have next to the panels and it gets full...
  2. C

    Outside temperature sensor reading higher than actual

    thanks for the reply. I guess my main issue with the temperature is with my solar system. Not sure if there is a way to get around this, my thought was the temp sensors. So I want to hear my pool, to say 88. Since outside is over 88, the solar kicks on to heat, but I want to supplement with...
  3. C

    Outside temperature sensor reading higher than actual

    I moved the sensor out of direct sun, but is still in the open. I measured the temp with a thermometer to compare. So I have 2 sensors, one by the equipment and one by the solar panels. I am not sure how the system takes them to determine the temperature. I measured the resistance of the...
  4. C

    Outside temperature sensor reading higher than actual

    This is a new sensor, jandy aqua link. outside temp is 90degrees, but the system shows around 97. can I just put in a resistor to offset it to read closer to actual? i figure a 1k resistor as per resistance charts that is the difference.
  5. C

    Jandy AquaLink rs and solar how to setup?

    well I figured it out. I’m surprised there is such a lack of info about this. solar in the setup needs to be turned on, when it does it will have a status ENA. you need to set a schedule to run the pool when you think the air temp is higher than the pool temp. ~11to5. when the pump is on and...
  6. C

    Jandy AquaLink rs and solar how to setup?

    Is there something that tells me how the solar operation works for Jandy? I’m not finding much. if I turn on the solar heat option it doesn’t seem to kick anything on. I have to turn the filter pump on also. Nothing turns off when temps reach their set points or when the ambient is colder than...
  7. C

    Jandy AquaLink rs and solar how to setup?

    Yea have it set as priority and dip is correc.
  8. C

    Jandy AquaLink rs and solar how to setup?

    I just added solar panels to my pool. have AquaLink Rs system. a jandy actuator 2444 and temp sensor by the panels. is there a way to have the system automatically open the valve and start the pump when the temp outside is higher than the pool temp? i cant seem to see this automation. I...
See more
Top Bottom
Back