Recent content by Chas717
-
C
Pentair MasterTemp not responding to ScreenLogic
Jim, Got it. I figured out my issue. With the 2015 MasterTemp, pulling the fireman's switch jumper and attaching the two control wires had the effect of completely disabling the MasterTemp control panel in favor of using the Intellitouch temperature sensor plus ScreenLogic. With this 2023...- Chas717
- Post #5
- Forum: Everything Else
-
C
Pentair MasterTemp not responding to ScreenLogic
Jim, Thanks for your reply. Yes, it is the two-wire connection, exactly the same as it was on my previous 2015 model MasterTemp 250. But with the prior model I could adjust the setpoint from within ScreenLogic which was, and remains, set up to do so. Only now changing the setpoint from within...- Chas717
- Post #3
- Forum: Everything Else
-
C
Pentair MasterTemp not responding to ScreenLogic
After 8 relatively trouble-free seasons my Pentair MasterTemp heater died (heat exchanger) and so I replaced it with a new one. It is integrated with a Pentair Intellichlor salt system and Intelliflow pump, controlled by IntelliTouch/ScreenLogic. Previously the IntelliTouch/ScreenLogic...- Chas717
- Thread
- Replies: 5
- Forum: Everything Else