Recent content by cgonzal2

Yes, most of the wires melted. But it just so happened that a different sister was replacing her Spa Heater. And the old one was just like the one that my other sister neede. Man, this can get complicated. I did re-wire the entire system at first until we found out that the wiring harness from...

This unit used to work until the heat in the cabinet burned up all the wiring. The circuit board had a burned trace as well, so I decided to just replace it. The electronic ignition was also damaged. So, I've replaced all of the major electrical parts, which were all damaged. New circuit board...

My sister had some issues with her pool heater. It turns out that the circuit board and all the wiring burned up. I replaced the circuit board, wiring, and gas valve. Once turned on, the "HEAT" LED on the circuit board fails to come on. The Service Light LED is lit. Any suggestions? I posted a...

Update: I found an open trace in the pcb. It looks like the thermal switch failed to open due to the heat in the chamber. The trace on the pcb burned. I replaced it with a wire. And plan on replacing the Thermal Fuse. I'll post tomorrow. cat

Hello to all, a newbie here, found this forum online and decided to try it out. My sister has a pool with a Pentair 400 heater. She had some problems with the control system. Got it all buttoned up and turned it on yesterday. The thermostat control card has 6 indicator led's. The service led is...