Recent content by CAVJOCK22

Folks,, I was just wondering if anybody out there can give me an idea what Im spending per month on the pool pump.. 4 hrs at 300 watts 4 hrs at 740 watts I pay .10KW/Hr

Re: LIQUIDATOR RATE OF FLOW WITH VARIABLE SPEED PUMP QUESTIO What about moving the fitting after the chlorine puck feeder (not in use) to between the filter and heater.

Re: LIQUIDATOR RATE OF FLOW WITH VARIABLE SPEED PUMP QUESTIO I didn't know if I could relocate the inflow fitting closer to pump or something?

FOLKS, NEED SOME OPINIONS HERE... I have a variable speed pump and have tried running at several speeds in the low range but it really affects my rate of feed from the liquidator. In the low speeds my rate of feed is at 0.. Take a look at the pics and see if there would be a better way to...

Re: New Pool - Conroe TX Platinum Pool built our pool. Was happy with the work they did. No problems too date on the pool or equipment. I chose them much for the same reason you did. I recommend the Iaqualink. It has been awesome. Recently added a liquidator and shut off the chlorinator...

Yes sorry. #7. Seven. 70 would be a bit tough and expensive.

In Houston. CYA is 60 so trying to get my FC to 70 by using the liquidator. Pool is crystal clear. Never looked so good.

10-4. I guess I'll give it a dose to bring it to the appropriate level and see what it does.

Also forgot to mention I have a variable speed pump and at low setting the flow meter us at 3 but when the pump sits at my higher RPM setting its above 5. It runs for 4 hrs on low the 3 hrs on high.

Question, Been a week know with the LQ installed and maxed out on the dial. My FC continues to be 4.5 PPM. Will it not increase my ppm over time. I have watched it and it looks like it is working properly. I thought I could raise the FC but maybe I'm wrong. Seems to be maintaining. Also...

Re: Liquidator ! Where to buy? Now installed! whoop Just finished installing the liquidator! Super excited. Install went very easy. I even tapped the fittings into my existing plumbing. All seems good. Current setting is between 4-5 with a startup reading of 4 for FC. What setting do...

Ok folks been doing the bleach thing for about 3 months and I don't believe Ill be using pucks anymore. Where is the best place to purchase a liquidator? I assume you can use bleach or chlorine? Thanks in advance!

Re: NEW STEREO RECEIVER GETTING TOO HOT AND SHUT DOWN, NEED My problem was one of the volume controls was switched incorrectly at time of install and it finally burned up. I bought a new one and before installing I double checked the switch location. Installed and haven't had any problems either.

My CH is still 425PPM. I have only used bleach since my last episode. Below are my readings from the Taylor K-2006 kit: FC 5.5 PH 7.9 TA 100 CH 425 CYA 73 I have turned off the tri chlor puck feeder to just a 1/4 on and have not used any cal-hypo again. My CYA reading on Monday was 79. I...

So the shock is what raised my CH. I guess I will start using bleach for shock. Anybody want to buy a partial used box of shock? Is it a good idea to shock before a rain storm?