Recent content by careingemt

thanks

I have homeassistant up and running perfectly ... I noticed there is an integration called "1-wire" I have the DS18B20 temperature probe which meets the requirements here : 1-Wire looking for help getting this setup I also have a raspberry pi 3B and 3B+ thanks in advance

Here is my flow switch (Flowing closed and not Flowing open ) i have a raspberry pi run a python script to obtain the status of the switch

Thats the biggest issue i have... (in-line) is the water temp the same as the actual pool water temperature when the pump is not running ?

No heater , Hayward (1 speed)

Asking for advise / a direction to go with automating my pool currently running Home-Assistant. I would like to incorporate the following : water tempature pump control flow switch (detects if pump is actually moving water)

:ROFLMAO::ROFLMAO:

wait a minute....

I just added a salt water generator (swim waves) this year (June 2022) which is rated for pools at 7,000 gallons. Optimum salt lelel is between 2500-3500. I used pool math to figure out the amount of salt needed in pounds. Tested my salt level with the TF-5600 test kit after 48 hrs and got...

thank you

page 14 gives salt range of 2500 and 3500 I'll add swg to signature