Recent content by Bulldogger

First place I looked. But if you look at the section that is apart, the diagram does not show it as coming apart. It's one single piece. However, it has a notch to properly assemble it and does come apart. I can't figure out what held it together. My only guess is some sort of glue.

I have a 2 year old Multiport valve that I removed when changing sand. It's not staying together when I try to mount back on filter pipe. Should it be glued? I see a notch but that's not holding it together.

In 2015, I think. I lost power from a snow for 2.5 days. That's why I didn't just leave the pump running. Thanks for RV antifreeze tip. Going out to see if I can get some at Walmart.

I've lowered my pool below skimmer, blew out lines as best I could with shop vac but am not sure I am protected from coming severe freeze. All pool antifreeze is sold out. I do happen to have 4 gallons of isopropyl alcohol. Would it be safe to pour it in the lines?

Thank you. I purchased a cord for a clothes dryer at Lowes and wired the black and red to the pump L1 and L2 and then wired the green wire to ground. Next I just hooked it up to my insider dryer electrical outlet and was able to test. The menus work and the motor does run. I didn't want to...

I purchased a pump on Ebay that is supposed to only have a damaged foot. However, right before the buyer shipped, I looked at completed auctions and saw he has sold the same pump last month. Sent several massages over last four days but no response as to why pump was returned. Not too big of a...

I was told it now has 10 smaller magnets to replace the 6 larger magnets the previous version had. Its a little more efficient but the real reason is the pump is more reliable. It would stop between magnets and give an overcurrent warning. Now there's more magnets to prevent the pump from...