Recent content by Bugman1400

Just the OT. However, I figured out the issue. Apparently, I can't even wire a 2-wire cable correctly. I had the wires rolled to the pump. All is well now. The 'Offline' display is gone and the correct speed and GPM are now displayed. Happy, happy. Joy, joy.

Just replaced my single speed main pump with a Pentair Intelliflo3 3.0 VS. I believe I've configured my OneTouch (OT) correctly and managed to get the pump to turn on, but the rotating display on the OT shows Intelliflo VS 1 (Offline) even though the pump is running. My AqualinkRS is the latest...

Does this pump work with automation systems like the AqualinkRS with REV T.2 chip?

As I now see, its the same issue as your previous response from last November. Will try same remedy you suggested then. Also, is it possible to drill all the way through the backplate to secure a nut and lockwasher on the other side? I would expect to use a longer screw and some silicone caulk...

My Jandy Stealth Pro Pump 2.0 HP already has issues in less than 2 yrs. The diffuser broke loose from the backplate and caused damage to the basket because of 2 little screws. Anybody got a simple fix for this?

Another UPDATE: You weren't lying about the Aqualink being quirky. After a few weeks of my Waterfall "ePump" VSP working as AUX Pump1, it suddenly just stopped responding to the Speed requests at the OT keypad. After an hour of programming and re-programming via the OT I decided to just change...

hmm....my main filter pump is single speed and not set up for VSP so, I set the Waterfall up as an AUX pump on Pump1 as the pics show for SW 3 & 4. So, that could be a problem if the Aqualink RS4 thinks the AUX Pump cannot be addressed as Pump1. UPDATE: It may be a flaw with the Aqualink T2.g...

When I followed the directions you created, I got all the correct HEX responses and the VSP came on for about a minute. So, it seemed to confirm, as you directed, that the VSP is responding to the Jandy protocol that would typically come from my Aqualink RS4 OneTouch. This VSP is not my main...

Well, the programming seemed to go well. I received all the correct HEX replies. However, my OneTouch controller doesn't seem to have any effect. I believe I programmed the OT correctly for the ePump. I have it set up as an AUX Pump, but I get no response when I select Speed1-8. Any suggestions?

Yes, it is the 165 model. I also have a USB to RS485 and will give it a go. Thank you, sir!

I have a non-EVO Century V-Green controller that I wired to my Aqualink RS4 (w/ CPU ver T.2) and tried to program it through my OneTouch keypad, but the VSP doesn't respond. It does respond locally at the pump keypad. Any suggestions?