Recent content by bryanq480

this test kit is the best Read the directions; it's fool-proof

make sure and get the 31.45 percent too

high fill TA here in Tempe...was 150-160. Daily acid additions and i will be able to get in down to 80-100 in no time.

ok cool - i will buy the refillable jugs; really appreciate it

dang OK, will have to give it a go as it's only about 10 minutes away from my house Is it truly 12.5 percent?

anyone in the phoenix/tempe/chandler/gilbert/mesa area ever purchased LC from A&M? I called, and they said it was $18.98 for 4 gallons of refillable 12.5% ( $8 deposit). I am currently getting 2 gallons of 10% at my local pool store for $7.99 ( Kem-tek was $5.99 at frys/kroger until a couple...

yep, that is the one i was able to adjust and bring the water level up a bit :)

pic of float

ok i will take pictures and then upload

Long story short - after replaster the guys installed a new pool auto float for some reason The water level seems to be about .5 - 1 inch too low. Do I raise or lower the actual float to increase water level height? Thank you; hope this makes sense. :)

so I use hair nets in my skimmer, should i take out the hair net before I put in the CYA? I think I will just put in skimmer as my pump runs 24/7 anyway.

ok how?

no heat pump here; i run hot hahah. Pool was about 75 degrees 2 weeks ago, and I imagine it will be the same tomorrow. Once it gets below 65 i am done - at this rate we can swim until thanksgiving hahah

in Gilbert huh? Still do dang hot here....just had our pool replastered and it's filling up right now. I plan on swimming tomorrow hahh