Recent content by browerjs

Thanks for that. So once I start seeing 2300, I should just change to T-9 on the controller? If I understand everything correctly, this will produce the same amount of salt and I shouldn't need to change my output %'s, it will just read at a higher level to allow for continued generation...

What reading do I need to get from the system for it to still be producing chlorine? Is it producing as long as the light for low salt is blinking and not solid?

I have a Hayward aquarite T-15 salt cell and when I opened the pool (~20k gallons) the cell was reading 1900. I put in 6 bags of salt and after about 24 hours it read 2800 (I've also seen this number drop depending the time of day) This seemed a little low to me as I was expecting more around...

I backwashed and when I turned on the heat via OmniLogic, the display on the heatpump changed from flo to bo, but the HP/fan never came on. I then turned off the bo mode, set the pool temp to the lowest it would go, set the spa to 104 and left it in spa mode. I turned the heat on via OmniLogic...

Last year I had a similar issue with the Flo error until I backwashed a couple times. Although I don’t think it was ever in bo mode. Unless that resets after power has been cut over the winter.

I called them and they were no help. I did find this manual later and have put it in the bo mode, but am getting the Flo error on 3400. I’m going to backwash tomorrow or the next day and see if that helps.

I am trying to get my Hayward Heat Pump model HP21254T into Remote Operation Mode so I can control it with my OmniLogic system. This was working prior to this year, but I think some buttons were pressed on the Heat Pump which took it out of the remote operation mode. I've been following page...

My Hayward Heatpump shows a temperature about 7 degrees lower than what the OmniLogic app/pad show. When I measure the actual water temp, it falls right in between the two. Does anyone know what might be going on? Omni controls the heat pump just fine.

I have a Hayward S244t sand filter and I need to replace my pressure gauge (needle stuck behind the pin). Everything I've read/watched says that you have to release the air prior to taking off the gauge, and then after turning the pump back on wait till water shoots out and then close the...

I actually did this last night. Turned off my SWG overnight and it looked like the FC went down about 1, maybe 2 (was 3-4 originally). This morning I dumped a gallon of liquid chlorine in and the FC is over 10. I also turned the SWG back on. Should I do this again tonight?

I opened my pool 2 weeks ago and over the last week I’ve been getting brown spots on the floor of the pool. It also tends to collect at the seams of the vinyl liner. I will brush it and it dissolves instantly, but just keeps coming back sometimes an hour or two after brushing. My pool water...

Clearance wise I think I’m ok. I’m not so worried about the blower if I’m not running it at night.