Recent content by Bp9906

Thank you both for feedback there. Sounds like a check valve would be an easy solution, though require some plumbing work. @wireform Do you happen know if this particular Jandy would let me take the cover off and adjust the end switch?

Makes sense. Thanks. So when the pool automation goes into freeze mode where it flip/flops between pool only and spa only every 30 minutes, I was seeing that when in Spa mode, the spa will drain back into the pool. I was thinking that the spa would drain from the spa center feeding during...

Pictures after shrinking a bunch.

Here is the DRAIN (Suction) and OUTPUT photos. I think ultimately the issue is the one I labeled "Spa Center" because I see water coming up center of the spa when in pool mode. I think closing this valve solves the problem. I did also close the vaccuum valve too at the time so could be either.

The MaxFlo XE pump manual states: Important: Any time power is removed and re-applied to the pump, such as turning off a switch or breaker, the pump will restart the daily schedule at the beginning of Interval 1. The start of the daily schedule will always be the time at which power is applied...

I generally see it triggered by me during a backwash where I’m pressing filter (off), changing the backwash lever, then pressing filter (on) all Less than 30 seconds. I’m raising the question only because it happened during freeze protection (ie automation and not by a person).

Hello, I’ve got a Hayward Prologic Controller with a Hayward Max Flo. The problem I sometimes see is that if you press the filter button (turns the pump on/off) too close together, then sometimes the pump receives power (indicated by the main power button lighting up) but the button simply...

Can you confirm you just closed the cleaner valve? I have the same problem. Shared cleaner and curious if closing the valve still allows water flow or maybe it’s not an issue.