Recent content by BigBillTX

+1 on the leaky factory fitting. Just installed yesterday and looked pretty good, checked today and there was a little bit of water, just a really slow drip, drip, drip. Removed the two plastic fittings, cleaned the Teflon tape and re-applied. No more leaky.

I decided to get the Dolphin Sigma, its a pretty cool bot but $$$, I like the way it runs the pool and floats along the waterline. I ended up returning it because it's so flat and low it got stuck on my rounded step on the bottom and would high center and just sit there. I'm going to fix my...

I just had a Polaris 9650i die today so I'm looking to get a new robot. 100% agree with Matt, mine lasted only 3 1/2 seasons and it's $450 for a new motor assembly (one side quit working) so I'm better off getting something new. As far as the bells an whistles, my 'i' robot lets me use my phone...

I am looking to add a tee fitting to allow me to put a digital gauge I can read with my home automation. I already have the digital gauge and got it working but need to tee into the existing port where the air release / pressure gauge goes. I found that I can remove the gauge itself and tee in...