Recent content by bgrinstein

Replaced 4 wired switch with 4 wire switch, with color translation as in the image below, the 4-to-4 (except that for one wire the switch has a see through insulation for what should be white). Flow switch has arrows (externally) so flow can be aligned: I assumed the arrows point in the...

My intellichlor IC40 has red and green alternating flashing salt level lights low-good; a steady red light for flow. Just like in this video pulled from the web: There are many posts about this and I have had this condition before. Yes, I have had the pool chemicals tested and they are all ok...

Thanks! It seems to be working fine. I was sure to move the valve all the way to ON (a little past it actually, until it clocked). Glad I did not agree to have the heater replaced (not yet!)

Hi swamprat69 -- if you are still there Let me start with the questions and below I will describe how I go to this point. After opening the panel I noticed that he Gas Valve (item 17, part 073998 in the diagram for minimax plus) was switched off. Switched to on and bingo, everything works! Here...

Thanks!

It's more like a glow than a spark, and a very faint glow at that. I am looking at it from below after removing the front panel of the heater, but of course is not very direct -- still I do not think my view is blocked. So a faint spark could mean there is some dirt or rust on the electrode? If...

I do see a spark at the pilot assembly, but no flame. To be sure I waited until dark and I see a faint glow at the assembly that turns off correlated with the RAT-TATA sounds (which I am free to turn on/off by turning the spa heat pot)

Thanks for the response and sorry to take time following up (went to work). The pilot is not lighting. I removed the heater cover and looked right into it, where you described; the ra-ta-tah continuous noise comes from there, but no flame

25 years old. Was working fine up to a month ago or so. I don't use often. Then a couple of times a few weeks ago it started heating from 60F got to about 75 and stopped. Pool guy came and replaced the high limit sensor. After that it worked once, got to 100 and then it stopped, would not start...

The pool heater (I only use it with the SPA) stopped firing. It makes the noise usually heard when it is trying to start the pilot, does not stop doing this and never fires up. I checked troubleshooting (see attached file, Mini Max Plus Service Manual) and found that the lights all come on...

Hi Jim Thanks again! So there are three leads, two read and one green. I assumed the green is ground and measured 240V between the two reds. Juts for completeness, between either of the red and the green is 120V. (BTW, teh cover of the pumps' control panel was off for the picture -- I do have...

Thanks, Jim, I do have a voltmeter, so I can go ahead with the measurements, but let me understand. First "the pump has no lights and no display" do you mean that the LED's on the control panel on the pump do not light up? (The picture I attach sown the panel) If that is the case, answer is LEDs...

I have a Pentair easytouch 8 with an IC40 and a VS intelliflo, installed 10 years ago. Was working perfectly until tow days ago. After city blackout two nights ago and power restored, the pump (intelliflo) won't go. Easytouch has power as does IC40, but pump does not seem to have power, not...