Recent content by BennyB1979

  1. BennyB1979

    Pentair Microbrite LED light slow failure or controller

    This thing is brand new. I’ll try that. The breaker has a reset button that has no resistance when pushed. I’ll try disconnecting the lights.
  2. BennyB1979

    Pentair Microbrite LED light slow failure or controller

    Yes. Reads .44 volts so nothing. I can’t get 120 v in. I’m getting 120 from the controller, but once I connect the white wire on the transformer I get no volts testing the same wires at the connection point. From what I’m reading the transformer protective circuit may be stuck open.
  3. BennyB1979

    Pentair Microbrite LED light slow failure or controller

    Also, the transformer has an overload reset. There is no resistance when I push the button. Wonder if something is wrong with the overload connection as I lose voltage when I connect the white wire. I’m assuming if the overload circuit gets triggered then the button would have resistance when...
  4. BennyB1979

    Pentair Microbrite LED light slow failure or controller

    I have 120 volts at the transformer from the controller. I have a new 300 watt transformer. Once I connect the transformer. Black (hot) to black on transformer and white to white, properly grounded I get no voltage at that point when testing the black wire. If I disconnect the white wires...
  5. IMG_2347.jpeg

    IMG_2347.jpeg

    • BennyB1979
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  6. BennyB1979

    Pentair Microbrite LED light slow failure or controller

    I’d say I found my problem. Ant infestation. Will likely need to replace the transformer and controller at this point. Fun fun. After some short research, it sounds like a traps and ant powder when installing new components will help with this. Took this picture after a few minutes. At...
  7. IMG_2291.jpeg

    IMG_2291.jpeg

    • BennyB1979
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  8. IMG_2290.jpeg

    IMG_2290.jpeg

    • BennyB1979
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  9. IMG_2289.jpeg

    IMG_2289.jpeg

    • BennyB1979
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  10. BennyB1979

    Pentair Microbrite LED light slow failure or controller

    Bump I’m finally about to start troubleshooting the lights. Any additional guidance would be appreciated.
  11. BennyB1979

    Pentair Microbrite LED light slow failure or controller

  12. IMG_1792.jpeg

    IMG_1792.jpeg

    • BennyB1979
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  13. IMG_1793.jpeg

    IMG_1793.jpeg

    • BennyB1979
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  14. BennyB1979

    Pentair Microbrite LED light slow failure or controller

    I have the older style Pentair controller.
  15. BennyB1979

    Pentair Microbrite LED light slow failure or controller

    I have three Pentair Microbrite LED lights connected to the Pentair light controller that has since been replaced by a newer model. Pool was installed in 2020. In 2022 , I noticed on of the lights would flash, become discolored, and then go dim. The other two lights were operating just fine...
See more
Top Bottom
Back