Recent content by av8042

Gary, thanks , that's exactly what I wanted to do. Sent from my iPhone using Tapatalk

Jason, Thanks for the reply. As I look at schematic and since I'm not using a relay for valve and just to make sure I have this right the Black wire is the common wire and the red and white are fed the 24volts respectively from controller?

I would like to automate valve to open and close pressure side cleaner line (Polaris 360 without booster) plumbed from between intelliflo pump and filter with energy filter. I don't need anything fancy and was hoping to use a sprinkler controller (24v output) to control the valve. Zone 1 move...

Hi guys, So I started to install all my new equipment. I poured a new Concrete pad for filter and pump and it's level frt to back , side to side and diagonal.. when I sit the FNS 60 on it, No matter where I sit it it leans towards the drain / valve side?? Are they designed this way. It's only...

Thanks for the quick reply, Maybe I didn't word it correctly. I would run the Cl200 off line with the 1", taking it off the 2" line to improve flow on the 2" line... It just seems leaving the Cl200 on a 2" (main line) is restricting its capabilities? Thanks again Sent from my iPhone using...

Hey everyone, I Have a 28k gal pool and am currently replumbing entire system above ground which includes Intelliflo 2vst pump, FNS PLus60 DE Filter Plumbed 2'' until it gets to pool plumbing circuits which are all 1 1/2" . 1 line for 3 returns , 1 line for skimmers, 1 line for Main...

Hi Again, Okay so I just read up on an energy filter setup after pump- before filter for pressure side cleaner (without booster pump) I had planned to plumb after filter before check and chlorinator? Is this something I need to consider? With such an oversized filter and a 3hp vs pump I...

I've decided to go with intelliflo 2 vst , FNS plus 60 de filter set up. I can run it at higher rpm while 360 is cleaning for a couple hours than kick it down when cleaner is not in use.

360 gets around great... Since the plumbing for the 2 skimmers (one line) and the Main drain are 1 1/2" i'll upsize to two inches at 3 way valve to pump, keep it two inches through filtration system and when it gets to 1 1/2" cleaner and return line(3 returns) I'll do same just opposite. I'll...

Hi Patrick, Thanks for the quick response . I've included a Proposed Set up of Equipment. In response to your suggestion to go with a robot I am trying to keep costs down. That is the reason why I would rather spend the addtl $275 on a booster pump trying to improve upon the systems...