Recent content by Andyroam

Thanks, I installed a motor (model 350105S), and replaced the shaft seal and gaskets using the saltwater kit from INYO pool (GOKIT32SALT), and it worked a treat. Andy.

Thanks, I'll get a motor ordered, hopefully that'll fix it. Andy

Hi TFP folks, My Intelliflo VS pump quits with an overcurrent error a few seconds after starting. This sad tale began when my spa was left running with heat, and while unattended, the top blew off the cartridge filter, allowing much of the water to escape. This lead to a waterfall of 95 degree...

Thanks for your help - I replaced the dead IC20 with a new IC40 and it's running like a champ. I left a small donation to TFP as this saved me from calling out a pool tech and the inevitable sales people. Best, Andy

Hi Jim, My pool's fairly irregular in size, but I'd estimate 12-13,000 gallons. That said, it's less than $100 to upgrade from an IC20 to IC40. Thanks, Andy

Hi Jim, You're absolutely right, and on checking I get 240VAC across the 2 line wires (yellow & white). As per your suggestion, I disconnected the cell and put a new fuse in the Power Center. The green LED lights up and stays lit, with a reading of 27VDC between the red and black wires that...

Hi All, My Pentair IC20 SWG appears dead with no lights. Looking through previous TFP posts, I figured I'd check the Power Center to check that it's getting power and passing that onto the IC20. First, checking the line input voltage, the transformer is getting 2 x 120VAC (yellow and white...

Hi Jim, Thanks, the Hayward manual gets us this far but then getting into the "E" mode for external control isn't explained... until I found an earlier thread on TFP... https://www.troublefreepool.com/threads/40209-Hayward-Summit-8TA-External-Controller-Setup ... which explains it all, and...

Hi All, First, I have to thank this forum for some advice I found here (using Google) about installing a Pentair Screenlogic2 wireless system to my pool controller - it worked so well that I registered here. Now to my issue: my pool control system (Pentair Easytouch/Screenlogic) no longer...