Recent content by AndrewTK

Thanks! I’ll add it and keep wait until it becomes available again.

I am looking for these motors as one of our Intellivalves is on its way out, it looks like the asin doesnt match a product on Amazon when i search it, any other details about the motor that you can share?

It has been relatively windy since we got back into town (no surprise in Oklahoma) and this morning i was able to get a better look at how the plaster turned out. For the most part it looks pretty even (walls, benches, tanning ledge, spa) all look good, but there are some places on the bottom...

Plaster was installed on Friday the 13th, they weren’t able to get back to acid wash until Saturday morning. We unfortunately had to be out of town for a few days so the builder took care of brushing the pool and getting the chemicals started. Water looks cloudy still now but is improving, I...

10 days later and we are finally expecting plaster, unfortunately our builder told us 4-5 times that the crew would be there the next day and they never showed up, seems as though they were having a hard time locating our plaster even though they had 8 weeks to order it. They assured us that...

They have hooked up the Intelliflo i1 for the time being but have ordered the correct pump. We are scheduled for plaster on Thursday or Friday, so hopefully all goes as planned and we will be filling the pool by this weekend

Builder dropped our equipment off today in preparation for plaster next week and we just discovered that they ordered the wrong pump for us. We specified the Pentair Intelliflo VS (part 011028) and they ordered the Intelliflo i1 (011059) which seems like an oddball pump for areas with size...

That is a footprint from our yard, everything around this area is red clay. We might do a spray deck on top of the poured concrete, going to talk to the builder to get an idea on cost

Concrete was poured today, they got off to a bit of a slow start because the hadn’t reconfigured the drain yet, took them about an hour to get that sorted out and start pouring. For the most part things went smoothly after that, though the second truck of concrete apparently had a bit too much...