Recent content by amgclk65

Its on the grout lines and a bit of the actually tile .

I noticed the water line that has more sun exposure does not get Alega build up. Wicked up water is evaporating quickly in that area. Now the portion of the pool that has a tile line is also getting Alega build up. Would that be a different issue?

@mknauss okay, Ill get my lazy butt brushing more often. I should've stated in my title , Algea above the water line. If that changes anything. So raise my FC for my CYA and brush more often. As far as Slamming, Not needed at this point? Due to the pool design.

@mknauss, Here is the tile line on the pool. The back side of the pool has no tile. All plaster, which I was told is a bad thing. The picture upload service is jacking up the picture orientation.

@Richard320 The algae is roughly on 35% of the water line. I did spray bleach and scrubbed the tile line and that did remove it for a few weeks.

65 cya, a little low for a salt pool. Granted I did check the chlorine loss over night and was inspec.

Hello, I've noticed Alega on the water line this summer. Or I think its algae. The water is nice and clear. I did raise the water level . I dont think that has any effect on it. Here is some pictures for analyzing. Any help would be awesome. FC: 4.5 CC: 0-0.5 Ph 7.6 Alk 130 calcium 550

I'll do the bucket test this weekend to be sure.

I haven't . I turned off the water fill valve some time last year. The water level has not dropped. If that means anything.

Thats what I was thinking. Im fine with my Dolphin and skimmer cleaning .

hello, I finally got the noise to go away. It was a leak on the suction side. Main drain to be exact. I'm running suction from the skimmer only and no noise or bubbles on the return. Ill have to redo the pluming from the main drain again. The pipes are off set (main , skimmer) coming from the...

Thx for the reply’s , I’ll go over my work.

Hey, @wireform I’ll get a picture of my subpar plumbing . @Jimrahbe All works to be honest. Triggers the swg at 500-600 rpms. Which is real nice for electricity concerns. I first noticed it on priming speeds. So i dialed back the priming speed to 1800 rpm. Also have it set to 1800 rpms for a...

hello, I Recently installed a Pentair IntelliFlo xf pump. Over kill of a pump for my setup, Got a great deal on it. I noticed the Pool filter making a slurping sound at higher rpm. Roughly 1500 rpm and over. I did notice some bubbles from the returns. I did check all the basic areas of common...

Hey, i figured it out. The RS432 cable was unplugged from inside the intelliflo drive units key pad. Took me a bit to figure that out. All works good now. Still have a few issue to work out. I noticed the pump scheduling within the App is limited to time only. It does not let me set times for...