Recent content by AMG

I found the connector online. Ideally now gotta figure out how to disassemble this one cuz then I could prob remove the broken pin, clean, reassemble , add some dielectric grease and get working again Edit: Spoke to the manufacturer. There is an extractor for this but the tool has two pieces...

I wish I could get this pin out of one of the 4 female sockets in the connector. Connector comes out but not sure if/how to disassemble the connector. Also doesn’t look like a part that is sold as pentair part, maybe it’s a universal style connector? I have a new cell, would prefer not to buy...

I have an RV and I have an anode rod in the heater that I replace annually. I had my pool converted to SW in 2012 and all has been good. I do not have a heater. I have been reading on a FB group about people installing anode rods in their plumbing as obviously that would sacrifice itself...

100% the fix. I checked with the volt meter before ordering and only one was bad , but I bought 6. Replaced both today in about 5 minutes. Easy cheap fix. Sent from my Nexus 5 using Tapatalk

Jbizzle: Any help here? I dunno whats up, I cant even upload another photo of the microswitches highlighted because of my quota or something? I tried even deleting photos above that were not too helpful and resizing some. Anyhow, basically look up top to post #7. You see in the bottom...

I think you are on to something with that. The lower microswitch was fully depressed. I used a tiny tool to lift it up and the motor started moving. A little bit after that the top microswitch depressed, but the motor didnt stop. It just kept going around 360-degrees until the bottom one...

Manually switching actuator from the advanced menu 28v on red then 28v on white. No movement on the actual unit. Checked voltage on the unit, same gig. I wonder how can I manually move the valve? The switch ON1 ON2 OFF of course is non functional. I did get 11v on the non active color...

Thanks, first time here. I feel I have read some stuff on poolspaforum though over the years when people talk about this. I think there was a TFP article written by someone about chemistry I read... well anyhow, glad I found this place today ! :) it's pretty hard to get my multimeter...