Recent content by akmiller78

It fit really well. I tapped rebar down periodically throughout the bottom (in a grid like fashion) and I used a transit to tape each piece of rebar where the bottom should be. The we hand troweled and pulled the rebar as we went past it. We did ok, but obviously that method would never give you...

Well it has been awhile and had a few small hiccups along the way but everything has turned out pretty great. Here is a picture of the pool and link to a google album of most of my construction pictures. Full album: https://photos.app.goo.gl/qBzWpB85sSHoV5wX6 Finished (mostly) Product:

Some updates. Have the equipment pad all plumbed and pool almost ready for concrete decking (coming Labor Day weekend I believe).

Still in progress. Along with my available time, a vacation I just got back from, and the weather (lots of rain) it has been a bit slow going. That being said, the walls are up and almost all leveled. The rain washed out some of my dig so there will be some re-work there but figure no reason to...

Dig is essentially completed. Have a bit of ground water in one corner as seen in this picture that I have to routinely pump out. I don't think it is enough that will cause any serious issues (I hope not). We have had a lot of rain here in the midwest up until about a week ago. Everywhere else...

The digging has begun....Hopefully finish off the dig this weekend then proceed to set the panels.

I'm doing a DIY Inground pool and looking to order my electrical cable for my feeder to my equipment pad (for variety of reasons my pad will be 100ft from my house and approximately 150ft from panel). I've already purchased the Pentair Intellicenter with the 150 AMP sub panel built in. I'd like...

Order has been placed. I ended up going with: - 20x44 - auto cover - 4'6" flat bottom with small cove - steel walls - 6ft tanning ledge - pentair vs pump - pentair 320 sq ft. cartridge - pentair heat/cool pump - pentair Intellicenter with swag I've been warned to not do the salt because of the...