Recent content by Airboy

Thank you sir. I've sent an email back to you. I'm looking for a good picture or diagram on the wiring. Sent from my iPhone using Tapatalk

Does anyone have a good write up/pictures of how to add landscape lights through a transformer on the easytouch? Thanks Sent from my iPhone using Tapatalk

Pentair has an update for the system, have you downloaded it yet? Mine stopped when I updated my Mac. Downloaded new updates and it's working again. Sent from my iPhone using Tapatalk

All lines are good. Just lost all communication with both sensors.

My Easytouch is showing 0F on both water and air temps. It was working 2 days ago but I've been out of town. Any ideas?, I don't think both would go out together.

No water in the pool yet, plumber used it to pressure test the system. Sent from my iPad using Tapatalk

Okay thanks, and yes it is a VS pump Melt In The Sun.

Plumber added salt cell as seen, manual says to have 12 to 18" of pipe prior to cell for best flow reading. Is this going to cause a problem?

Building a 18,000 gl in-ground in AZ, plumber says Pentair 342000 is a good choice. I'm adding an easytouch 8 with salt. Is the superflo the best choice for automation? The manual doesn't really go into detail about it. Also I will add a heat pump and 3 deck jet later on, no spa or other water...

I'm a home brewer so all my beer ends up in 5 gallon kegs. I will ask for the "locator wire" and a room for the "laser" :)....Thanks for the help, I'm just getting started.

I'm not bending myself, I have two bids. One heat bends and one doesn't. The difference is a few hundred dollars and I'm trying to figure out the advantage of either. One plumber says flow, the other says repair ability.

I am doing an owner build in AZ and I'm wondering if there is a real advantage to heat bending over fittings? Flow vs. repairability? Anyway, any thoughts would be great thanks.