Recent content by afliime

thanks for the responses.

After coming across this thread Heater only fires up well above minimum 25gpm and seeing that the issue may be the check valve, that may be my issue as I have one as well. When I open up the pool I'll temporarily remove the flap and see if that makes a difference.

Thanks for the feedback. My neighbour has the exact same setup as mine (exact same equipment, pool design, pipe materials/size, layout) and his heater shouts off is his pumps goes below 1900 rpm. So I was wondering if it had to do with the programming of the Prologic automation?

Moved from here.. VS Hayward pump rpm to activate Hayward Heater flow switch If my pump runs below 2750rpm. the heater will turn off (LO). From my research I think I can alter the rpm by playing with the pressure switch inside the heater to allow a lower rpm setting to run the heater?

FYI, I purchased the taylor k-2006 off amazon for $140 cdn. I see the same test kit goes for $210 at Pool test kit canada.

I can't even imagine your gas bill :eek:

welcome to tfp!

another torontonian!

Harish, how is your pool working out?

any update?

:(

Very happy for you!

I am wondering the same thing as I was quoted $4500 CDN for 3 steps that are 6 feet wide for vinyl over steel.

Looking good.

yes many places in toronto offer banas stone, senso group supply....beaver stone suppy, islington suppy yard.