Latest activity Postings Media About
-
-
Dirk replied to the thread 10 Day Old IC-40 Just Went Dark.It's only one side leaking, right? You could swap the o-rings, one end to the other, to see if it's the o-ring or not. -
The union / o-ring, not the welded pvc to coupler connection. Folks upload to YouTube then link the video that way. I don't...
-
The piping lines up well. I install the cell by starting on one side with three or four turns at the union to get the threads engaged...
-
I inspected the "old" o-ring (only 3 weeks in service) and the brand new o-ring very carefully, both felt and looked fine. But I...
-
I may have used too much lube. I may also have over tightened. "If it's worth doing, it's worth overdoing" may have bit me on the...
-
Dirk replied to the thread Intelliph and Intellicenter.In the first pic above, note the screw and washer holding the IntellipH base to the pad. They've got some rust on them, but I think...
-
Dirk replied to the thread Intelliph and Intellicenter.No. There are lots of stirrers available, just not one that will fit through the grid of an IntellipH. Which is why I fabricated it. I...
-
-
Dirk replied to the thread 10 Day Old IC-40 Just Went Dark.Other things to recheck. I think you said you replaced the o-ring and that didn't help. If not, do. Feel the o-ring all the way around...
-
It's glued to the PVC and all but indestructible. Usually the pipes or pad settles and they no longer line dead up. The union...
-
Dirk replied to the thread 10 Day Old IC-40 Just Went Dark.I'm in the other camp, I can't get things tight enough with just my hands anymore. I use a giant pipe wrench to give an extra 1/8 turn...
-
Also be mindful of overtightening. It took me 5 seasons to realize that as a big dude, my hand tight was tighter than the retirement...
-
Dirk replied to the thread IC40 says salt level is low while salt level reads 3800ppm. New flow switch added..Ha, I just read that back and it sounded a bit like a payola scheme. To be clear, the money you donate to TFP goes to infrastructure...
-
Dirk replied to the thread Intelliph and Intellicenter.Yep. I couldn't say. Mine is going on 5 years and it's fine. I'd be concerned about running it underground. Your PVC idea is good, but...
-
-
@Dirk - exactly what i was looking for thanks!
-
Dirk replied to the thread Intelliph and Intellicenter.I probably wrote to route the tube as far away from metal as possible, not getting a longer tube. I wouldn't try 100', though...
-
-
Loading…
-
Loading…
-
Loading…
