My Circupool RJ60+ will arrive tomorrow and I’m planning to install it. I wanted to put my latest chemical tests here and see if anything needs to be adjusted prior to installing.
FC - 8
TA - 130 - 140
PH - 7.4
CYA - 70-80
Salt - 600
I think the TA is high but not sure how / if I should bring that down before installing. Any thoughts?
Should I plan to have Muriatic acid on hand to lower PH?
I plan to put the salt in (480 pounds) and then install the SWG. Is it bad if I put the salt in and then have the pump off while installing? Or should I dump in the salt after installing?
Any help or advice is appreciated!
FC - 8
TA - 130 - 140
PH - 7.4
CYA - 70-80
Salt - 600
I think the TA is high but not sure how / if I should bring that down before installing. Any thoughts?
Should I plan to have Muriatic acid on hand to lower PH?
I plan to put the salt in (480 pounds) and then install the SWG. Is it bad if I put the salt in and then have the pump off while installing? Or should I dump in the salt after installing?
Any help or advice is appreciated!