Jandy AquaSeries Ei Pure No Flow Indicator On

[xclaim494]

Guys I just plumbed a Jandy AquaSeries Ei Pure : Its the Salt Cell that is installed upwards (not horizontal) :

I keep getting he no flow indicator - this brand new unit : Also I have a Variable speed Pentair Pump
the salt cell is half full at 1750 RPM and Full at 3000 RPM - Do i have to run my pump at full speed ? Seems inefficient ?

am i doing something wrong

any workarounds there to run pump at lower speed but with full water in salt chamber ?

 

[xclaim494]

Any ideas?

 

[ping]

Does the no flow go away with the pump at 3000 RPM?

This SWG requires 40GPM which is a significant amount for a SWG. The design is no longer being distributed from Jandy, hope it is not new.

 

[xclaim494]

Does the no flow go away with the pump at 3000 RPM?

This SWG requires 40GPM which is a significant amount for a SWG. The design is no longer being distributed from Jandy, hope it is not new.

thanks for the reply

It is new so i can send it back for a full refund - I tried everything - Even busted by filter while at it : Is there a comparison by SWG with GPM's - I guess is I should be looking at lower GPM's

Thanks.

 

[ping]

For your size of pool I would get a CircuPool RJ60 sized system. The flow should be in the 10 to 15 GPM range, check a manual.