Hi all, my pool automation was set up for SWG by the previous owner so the aqualink has the chlorine generator, board, interface, and wiring all there. At some point prior to my ownership, they remove the salt cell and put a tablet feeder in its place.
However, now I want to reintroduce the salt cell. Looking for the best place to mount it. Here is my setup.
Am I right in thinking it should be as simple as plumb the salt cell in, connect the power to the existing pigtails in the aqualink box and plug the tri sensor harness into the board thats right next to the chlorine generator transformer ?
However, now I want to reintroduce the salt cell. Looking for the best place to mount it. Here is my setup.
Am I right in thinking it should be as simple as plumb the salt cell in, connect the power to the existing pigtails in the aqualink box and plug the tri sensor harness into the board thats right next to the chlorine generator transformer ?
Attachments
-
20231013_094427.jpg663.4 KB · Views: 35
-
20231013_154733.jpg733 KB · Views: 22
-
20231013_154757.jpg717.1 KB · Views: 23
-
20231013_155006.jpg472.5 KB · Views: 21
-
20231013_155040.jpg548.7 KB · Views: 14
-
20231013_155043.jpg446 KB · Views: 12
-
20231013_155049.jpg464.1 KB · Views: 13
-
20231013_155122.jpg479.8 KB · Views: 10
-
20231013_155127.jpg197.2 KB · Views: 16
Last edited: