Hey everyone. Turns out my liner somehow was shot so I had to replace so now I'm filling up my pool. I'm a rather newbie so I wanted to make sure that I'm balancing the chemicals in the proper order. After the pool is at the right water level, I assume that I would have to:
1. Get salt levels to proper level.
2. Get pH to proper levels.
3. SLAM
4. Get CYA to 60.
5. Get TA to proper levels.
6. Get CH to proper levels.
Is this correct? Or should I get CYA to around 30 and then SLAM? Any help would be greatly appreciated.
1. Get salt levels to proper level.
2. Get pH to proper levels.
3. SLAM
4. Get CYA to 60.
5. Get TA to proper levels.
6. Get CH to proper levels.
Is this correct? Or should I get CYA to around 30 and then SLAM? Any help would be greatly appreciated.