thoughtlessly tried to use channel locks on this and snapped it. Put a prybar in there and the notches snapped out. How in the world can I remove this thing now?
Snapped jet line and now I can't get it out
- Thread starter juuuceboy
- Start date
thoughtlessly tried to use channel locks on this and snapped it. Put a prybar in there and the notches snapped out. How in the world can I remove this thing now?
- Jun 22, 2014
- 48,236
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
Welcome to TFP! 
You might consider cutting a small groove on the edge of the fitting so that you can insert a screwdriver and gently "tap" it counter-clockwise to get it moving.
You might consider cutting a small groove on the edge of the fitting so that you can insert a screwdriver and gently "tap" it counter-clockwise to get it moving.
Lake Placid
In The Industry
- May 27, 2021
- 694
- Pool Size
- 17000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
You can also try a set of long 90 degree needle nose pliers to grab on to the recessed plate in the fitting to try and spin it out.
Similar threads
