Upon opening my pool recently, I was seeing 2 error codes and the service light on my panel. Inspection of the cell showed buildup but cleaning revealed that the center rod had fully corroded at the top plate so replacement is required. I have read that replacement of the power cord is recommended. Is this universally the case even if mine shows zero signs of wear, corrosion, etc? Also, is it recommended that the Port Sensor be replaced too? I have not pulled this to investigate its condition, although no indications of malfunction have been experienced, but want to make sure if I'm going to these lengths (and cost) that I'm getting this done right.
Thanks in advance for any input!
Thanks in advance for any input!
Last edited: