Hi, I've been reading the forum posts and didn't find the exact answer to the issue I'm seeing and was hoping for some help before I call Pentair tomorrow.
I have a 3HP variable speed pump that has been working fine for the last 3 years (install date 5/1/2020) but all of a sudden it stopped working yesterday; no display at the pump, no signal via Screenlogic/automation. I checked the breakers, and confirmed there is 240v at the pump and the relay is working with I turn it on at the panel. I live in Austin, TX, so no lightning recently and the pump wasn't making any funny noises prior to it going out.
Based on my research, it sounds as if the drive unit went bad, but the pump and LCD are still ok?
If the above is correct, a few questions:
Rich
I have a 3HP variable speed pump that has been working fine for the last 3 years (install date 5/1/2020) but all of a sudden it stopped working yesterday; no display at the pump, no signal via Screenlogic/automation. I checked the breakers, and confirmed there is 240v at the pump and the relay is working with I turn it on at the panel. I live in Austin, TX, so no lightning recently and the pump wasn't making any funny noises prior to it going out.
Based on my research, it sounds as if the drive unit went bad, but the pump and LCD are still ok?
If the above is correct, a few questions:
- Given I'm 5 months out of warranty, would Pentair definitely not warranty?
- If they don't warranty, is it possible to repair the drive unit?
- If unable to repair, does getting a used one (1/2 the cost of new) present any major issues?
Rich