- Jun 15, 2019
- 24
- Pool Size
- 30000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
My pool equipment is above water level. If I need to open plumbing on the return/pressure side for a repair, couldn’t I set MPV to re-circulate to prevent water and DE from Draining out of the filter? On suction side I have a check valve between pump and MPV/filter and for extra measure a Jandy valve before pump I can close.
I had a slow leak at one of the heater connectors at glue joint last year and can’t remember which one. I’m going to replace both before I re-open for the season, but was just curious in case I need to open the return/pressure side during the season. Picture from when equipment was installed.
I had a slow leak at one of the heater connectors at glue joint last year and can’t remember which one. I’m going to replace both before I re-open for the season, but was just curious in case I need to open the return/pressure side during the season. Picture from when equipment was installed.