Master temp set at 104 with screen logic and htr set to 104 but screen logic only gets to 101. Feels like 101.
Mastertemp and screen logic not the same temp
- Thread starter Ricky P
- Start date
- Jul 21, 2013
- 53,057
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Use your multimeter and test the water temperature sensor connected to the EasyTouch and the thermistor temperature sensor in your heater and see which one is off.
It helps to know the actual water temperature using an accurate thermometer.
www.troublefreepool.com
It helps to know the actual water temperature using an accurate thermometer.
Temperature Sensors - Further Reading
www.troublefreepool.com
- Jul 21, 2013
- 53,057
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Rick,
You can use ScreenLogic and calibrate the water temp probe.
See this set up page.
It does now work well if you try to make big changes.. Change it about 3 degrees and save it and then you can do it again.
Thanks,
Jim R.
You can use ScreenLogic and calibrate the water temp probe.
See this set up page.
It does now work well if you try to make big changes.. Change it about 3 degrees and save it and then you can do it again.
Thanks,
Jim R.
Similar threads
