Hi! Good to see so much progress. I will answer each part of your post in .red
Use the pool calculator to find out how much of each chemical to add. You will need to raise your FC, pH is good, leave TA alone if you plan to add borates. Adding borates will bring the TA up if you use 20 Mule Team Borax. Add enough CYA to get it up to 30 to start and you can fine tune the level from there.
Good luck finding that leak!
SPKNout4CHRIST said:Do you believe the epoxy would work there? If so, I could try patching it with that before having to rework the plumbing. If it is the plumbing leading to the heater and not actually part of the heater then I would give the epoxy a try. If it is leaking from the heater itself then I will let one of the pool industry experts answer.
So we got the bottom sparkling clean today!! It has come a long way since we started the process and today I could see the results with the sparkling water in the sun!!! There is a questionable spot in the corner where I think there may be a hole. When you clean out the dirt there it looks a little dark still (the liner looks dark, all of the dirt has been vacuumed from there), unlike any other corners. Within 5 minutes it seems that dirt has accumulated there again in that exact same spot, but not anywhere else near it, so I am thinking that could be the culprit. What do you think? Sounds like a good spot to check out.
Also, I completed a full test of numbers since I know I probably need to start getting those back to normal since the water has been holding and I may need to get in to fix the pool. Below are the results. Where should I start with those? Thanks again!
FC: .5
CC: 0
pH: 7.2
T/A: 40
CH: 40
CYA: 0
Borates (I had these in there before the water drained so I would like to add back unless recommended otherwise): 0
Salt: ~250
Use the pool calculator to find out how much of each chemical to add. You will need to raise your FC, pH is good, leave TA alone if you plan to add borates. Adding borates will bring the TA up if you use 20 Mule Team Borax. Add enough CYA to get it up to 30 to start and you can fine tune the level from there.
Good luck finding that leak!