One other possibility. You can unplug the PCB then plug it back in. It maybe is not seated properly.
I’ll try that thanksOne other possibility. You can unplug the PCB then plug it back in. It maybe is not seated properly.
I wanted to stay on this thread but another question I decided to use the cleaner and solar jva plugs for a fountain and water slide can I rename those on the web application. Also I want to have the booster pump for those selections how to I assign and make those action occur when selecting those? ThanksI’ll try that thanks
I went back and look at your photos and have the following question.I have three VSP’s two are used as jet pumps one supports rear jets in my spa and the other side spa jets. The trick is I also have the deep end fountains which is on one of the jet pumps and a water slide and shallow fountain on the other jet pump.
Where do I find which aux my booster pumps are assigned to?I don’t think you can change the name of the JVA name (or Let’s say I have not figured that out) but it does not matter. What you want to do is assign the respective JVA to the correct auxiliary. So we need to see how your current auxiliaries are set up. See screen shot. So for instance if your booster pump is set up to the #3 auxiliary then whichever JVA you plug into the Solar socket needs to be assigned to the Aux 3. Then same for your Cleaner Socket.
The concern I have, and I think I expressed it in an earlier post, if the same pump runs the slide and the water fountain but you have 2 different JVAs., I Think the software will activate them both so you have to have 1 open and the other close.
After you assign the JVA to the pump. Go to the Home Screen set up and select the Booster Pump for the Home Screen.
I have attached my screens as a reference. So if you can screen shot each one on your system then we can walk through the set up.
Note- if your PCB is not powering up - then you may not be able to have access to the setup screens.
View attachment 493275View attachment 493276View attachment 493277
Ok crazy but it appears the subpanel is now working except the jva to B1and B3 are not activating. I noticed the wire in my photo was not connected. I do t know if it’s supposed to NOT be plugged in are J12,J13 and J14 tied to the function of the jva. I know that disconnected wire comes from a relay. Sorry for all the bouncing around and I appreciate you sticking with me.Where do I find which aux my booster pumps are assigned to?
Side note since my sub panel is not working that’s why I desired to use the solar and cleaner jva sockets on the main board. Can you just give me step by step what and when to click something to accomplish this task.
I want to be able to select my equipment and from that select water slide and the boaster pump and correct jva get activated.
I don’t need to action the extra jva I’m just going to refuse the speed of the pump which will satisfy the needs.
Boy a 5 minute phone call would help ha!
This is what I am trying to get to but need those screen shots to guide my response.I want to be able to select my equipment and from that select water slide and the boaster pump and correct jva get activated.