I am trying to program my EasyTouch to do a quick clean. I want it to run the pump when I turn a circuit/feature on and run for 20 minutes.
I have tried a lot of combinations but the pump isn't lowering back to its low speed after the egg timer set time.
This is what I have currently:
Circuit 4, Name Pool High, Function Generic
Pump Speed on Circuit 4 Pool High 2600
Program 2, Pool High On, Egg timer off at 1 minute (1 minute just for testing purposes)
When I turn Circuit 4 Pool High on the pump speed ramps up to 2600. But then it doesn't lower it back down after 1 minute (or even 10 minutes).
I have tried a lot of combinations but the pump isn't lowering back to its low speed after the egg timer set time.
This is what I have currently:
Circuit 4, Name Pool High, Function Generic
Pump Speed on Circuit 4 Pool High 2600
Program 2, Pool High On, Egg timer off at 1 minute (1 minute just for testing purposes)
When I turn Circuit 4 Pool High on the pump speed ramps up to 2600. But then it doesn't lower it back down after 1 minute (or even 10 minutes).