I know this is an old thread but just want to say thanks for all the info here. I've watch so many youtube videos but none has good info about the ultratemp and the intellicenter. I'll try this last suggestion using the RS485 and solar sensor.
The pool company supposedly installed the HP to use relay but it has never worked on the intellicenter and my board doesn't show any cables !?. Pic of my board attached. The current RS485 A wire is for my superflo VS pump I just installed to replace a single speed superflo.
Do any of you have any issues with the circuit breaker tripping when the HP is on and tries to start after temp drops? This happens to me so I have to use the HP in this order: Turn HP off, make sure temp is set lower than water temp, then turn the pump on and change the set temp higher than water temp. If I don't do it in this order my circuit breaker will trip and I have to start all over.
TIA.
Moved from here.
The pool company supposedly installed the HP to use relay but it has never worked on the intellicenter and my board doesn't show any cables !?. Pic of my board attached. The current RS485 A wire is for my superflo VS pump I just installed to replace a single speed superflo.
Do any of you have any issues with the circuit breaker tripping when the HP is on and tries to start after temp drops? This happens to me so I have to use the HP in this order: Turn HP off, make sure temp is set lower than water temp, then turn the pump on and change the set temp higher than water temp. If I don't do it in this order my circuit breaker will trip and I have to start all over.
TIA.
Moved from here.
Attachments
Last edited by a moderator: