Was throwing "CE", replaced display board. Started throwing the board error, replaced main board, now getting "IF"
Goes through all the steps, Infighter glows red, I smell gas. Will not light, throws "IF".
The weird part. I removed all of the gas nozzles to check for clogs and they were clean.
To remove them, I rotated the lower portion of the black gas pipe out and up so I could get a wrench around the nozzles.
I turned it on in this configuration (No nozzles and gaspipe, lower section rotated away / out) to see if I could feel the gas coming out.
To my surprise the thing lit. It ignighted and hot air was shooting out the top like when it is functioning normally. I clearly don't know how this machine works because I assumed the nozzles were the source of fuel for the heater.
I shut it off quickly and replaced the gas nozzles and rotated the pipe back into place, buttoned it all up and it is back to "IF" 3 attempts then throws the "IF" code.
Goes through all the steps, Infighter glows red, I smell gas. Will not light, throws "IF".
The weird part. I removed all of the gas nozzles to check for clogs and they were clean.
To remove them, I rotated the lower portion of the black gas pipe out and up so I could get a wrench around the nozzles.
I turned it on in this configuration (No nozzles and gaspipe, lower section rotated away / out) to see if I could feel the gas coming out.
To my surprise the thing lit. It ignighted and hot air was shooting out the top like when it is functioning normally. I clearly don't know how this machine works because I assumed the nozzles were the source of fuel for the heater.
I shut it off quickly and replaced the gas nozzles and rotated the pipe back into place, buttoned it all up and it is back to "IF" 3 attempts then throws the "IF" code.
Last edited: