Hello. I am looking to install an aluminum ornamental fence around my inground pool. The over dig was filled with number two sharp limestone. My question is, what do you suggest using to auger the holes for the fence posts? Will an auger be able to cut through without collapsing? Has anyone tried the pneumatic i beams posts in this scenario? I prefer not to dig this by hand if possible. Any suggestions would be greatly appreciated! Thank you.
Fence install
- Thread starter rraabb11
- Start date
- Jun 22, 2014
- 48,268
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
Hello and welcome to TFP! 
Did you ever figure out the best way to complete that installation?
Did you ever figure out the best way to complete that installation?I did. Auger, post hole digger, and sono tubes. Thank you for checking in!
