While working inside my high voltage box today I noticed one relay which had 3 wires tenuously attached to each of the line spots. I was going to go ahead and pigtail it but in the process of disconnecting it the plastic broke apart and rendered the relay unusable. After looking at it more carefully he had 3 wires connected to Line 1 and 3 wires connected to Line 2 with nothing connected to either load spots. The relay also corresponds with the waterfall circuit which is a VS Intelliflo pump wired straight to a breaker.
Unless I'm thinking about this wrong is there any reason line voltage even needs to be connected to this relay since there's no load? Or am I safe to just wire nut each line set together and disconnect the bad relay from the board?
Thanks
Brian
Unless I'm thinking about this wrong is there any reason line voltage even needs to be connected to this relay since there's no load? Or am I safe to just wire nut each line set together and disconnect the bad relay from the board?
Thanks
Brian