Hi folks, I don't post often but when I do you guys have been a great help so thank you in advance. I have had a pool service taking care of my pool since I owned it and I really need to start to understand my setup more. Right now I think there is a problem with the setting of my valves/actuators. Previously what seems to happen is the limit switch inside wears out and needs to be replaced. I found a video on youtube where they teach you how to do this for $1 and it's saved me numerous times in the past when pool guys want to replace the actuator. Unfortunately my problem is that I never fully documented the position settings. Attached is a picture of my pools valves while in pool mode. Does anyone see anything wrong here? If not, when I turn it on to spa mode, both actuators should move right? Is it 180 degrees for both? Again, just trying to understand the very basics of positioning at this point so I can fix that and then move onto bigger concerns. Thank you again!