I have everything installed on this RJ45+ except wiring.
This SWG will be wired through my Intelliflo3 pump relay board. The left relay is my pool light 120v and the right is my 220v Spa Blower.
I am going to have to use the two wires from the pool light for this config.
Will I have to config SWG as 120v since I only have the two wires run through conduit?
Maybe in the future I can run two more wires to make it 220v.
Doing this will it matter if its 120 or 220?
Will the 5amp relay be enough? I could flip them, spa Blower uses under 5 amps
This SWG will be wired through my Intelliflo3 pump relay board. The left relay is my pool light 120v and the right is my 220v Spa Blower.
I am going to have to use the two wires from the pool light for this config.
Will I have to config SWG as 120v since I only have the two wires run through conduit?
Maybe in the future I can run two more wires to make it 220v.
Doing this will it matter if its 120 or 220?
Will the 5amp relay be enough? I could flip them, spa Blower uses under 5 amps