I have Aqualink Z4 on a pool-only setup. 1 waterfall JVA on aux 3. I had to replace the interface due to LCD display becoming completely unreadable.
After initial setup to set VSP mode for the pump, I notice the system now thinks I have a pool/spa setup.
I used to be able to just switch Aux3 to use the JVA for waterfalls, now that seems to be tied to 'spa' mode, ie, I have to select spa mode (pool pump shuts off, JVA activates, then pump starts again).
How to I get it back to pool-only mode?
Thanks!
After initial setup to set VSP mode for the pump, I notice the system now thinks I have a pool/spa setup.
I used to be able to just switch Aux3 to use the JVA for waterfalls, now that seems to be tied to 'spa' mode, ie, I have to select spa mode (pool pump shuts off, JVA activates, then pump starts again).
How to I get it back to pool-only mode?
Thanks!