@ogdento Hey Tom, hope you are well. As we get into the cooler weather I have started using my heater and wanted to run something by you. honestly i lost track but think i have your board right? and you kept mine? i ask because i have a new issue ;(. i think i have your board so i'd guess it is not the board which may be more concerning. the other day i fired up my hot tub and set thermostat to ~94. after a bit i came out and stepped into the hottub and it was clearly hotter than what i set. opened my app and it showed 103! and the heater was still running. i turned it off in the app on the hottub screen and it did not turn off. i had to go into features and power down the heater. i have since confirmed this happens everytime. when i turn on the heater in features it fires up immediately and have no temp control as i used to. i am not even sure i have it setup right in the app but it has been this way the entire time and has always worked. @Jimrahbe helped me program it originally but i may have figured that part out on my own so if its wrong i am sure that was me.
do you think this can be the controller? i guess i will have to disconnect the interface and test manually but i need to dig out my manual because i recall having to set a jumper on the heater when i connected it to the easytouch.
thanks!
do you think this can be the controller? i guess i will have to disconnect the interface and test manually but i need to dig out my manual because i recall having to set a jumper on the heater when i connected it to the easytouch.
thanks!