How can I get the bugger off, I dont want to replace the motor without putting seal back on. and I just wanna be able to get this bolt out so I can have pc of mind as well
3 other bolts are missing from the seal plate on my pump, my motor stopped working last night and I have a replacement sitting here ready to go but cant get the seal plate off
1 bolt is all holding it on
its not coming out tried, so I purchased from HD supply to get a new seal plate
and seal 75.00 total didn't think was too bad, just hope now it was the motor not the pump that has quit working
All that has been taken care of, another question that I now have and it might be a no brainer but I have no brain. So when I am full skimmer, which is how I think I will need to run my pool vac the pump doesn't stay primed as if it were on skimmer and bottom drain mode, is this normal, or something amiss???
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!