Search results

  1. M

    Aquarite SWG reading 0 salt

    Yes local store that has the Hayward test system. It passed and i could see gas exiting from the open end. That is what makes me hesitant to purchase a new cell. Unless it is working but not to its full capabilities?? If i do purchase a new cell what are the aftermarket/generic recommendations...
  2. M

    Aquarite SWG reading 0 salt

    @JamesW , Thank you for the video. Yes it was set to metric, but making that change did not produce any change in salt reading. Unless it takes multiple hrs to register. I did try to run the calibration as suggested as well, and again no change. Still reading 0 for salt with check cell & check...
  3. M

    Aquarite SWG reading 0 salt

    Thank you for the links. Pool is 16k gallons. I’ll check voltages on the board,but my gut is telling me something with the cell, even though I saw the chlorine gas being expelled. As far a generic cells what others are available that have proven successful?
  4. M

    Aquarite SWG reading 0 salt

    Out of the blue my T15 swg is reading 0 for salt. I've check salt via test kit and pool store and there is plenty, 3200. Had pool store check cell and they said it passed and I could see gas rising out while they tested. Cell was installed in 2019 and is out of the 3yr warranty. Readings in off...
  5. M

    Did i screw up my flow

    Thank you... Impeller was the same part number as original. Filter is a cartridge filter only a few months old, and i tried running the pool without it as a test and there was no difference. One thing i did notice was that the two fixed heads in deep end stayed down until i turned off my water...
  6. M

    Did i screw up my flow

    Hoping the brain trust here can help. 16K Gal pool, 1.5HP Pentair whisperflo pump, 1HP pump to solar heat, Paramount in floor cleaning system. Hayward SWG. Here is the issue. Pool originally came with a chlorine feeder, i had the Hayward SWG installed. Shortly after i noticed that the heads in...
  7. 20200110_164711[1].jpg

    20200110_164711[1].jpg

  8. M

    Solar pool heater not heating

    Looking for help from the brain trust. Solar heater not heating. I've ohm checked the sensors and they are ok. I can switch on man/test and booster pump turns on. Water that initially comes out is hot. Then normal pool temp. No errors or trouble lights on controller. Any ideas? All help...
  9. M

    Generator not reading salt correctly

    Thanks James.. S/N: 3E14345-202241 I did calibrate it again after i posted the above and had 4100 salt reading, but it has been dropping since then. After shutting off for a couple of min: 3400 69 27.3 5.56 65P -2800 If it is the cell are other brands as reliable as the Hayward? The pool is...
  10. M

    Generator not reading salt correctly

    Hello all, I currently have an Aquarite Swim Pure SWG with a hayward Swin Pure + t-15 cell. When i take salt readings via Taylor drop test kit i get readings of 4100, but at my control panel it is reading 2600 and flashing to check salt & cell. I have cleaned the cell, calibrated multiple times...
  11. M

    Failed solar controller

    Hello all, Due to hurricane Erma i had to have my roof replaced :(. Roofing Co completed the job and a solar Co mounted my panels. The only issue is they said my controller is not functioning and needs replacement at $400. My symptom is that my booster pump will not turn on so no water flows up...
  12. M

    Do i have a problem????

    Thanks guys. Here are my readings from this morning. The pool actually looks clear. I can clearly see the phillips heads on my main drain. Just a small amount of green here and there which might be pollen. PH 8.2 FC 1.5 CC 0 TC 1.5 CH 600 CYA 180 done with a 50/50 tap/pool water TA 140...
  13. M

    Do i have a problem????

    OK got my test kit yesterday. Here are results: TC 1.5 FC 1.5 CC 0 CH 650 TA 140 PH 7.5 CYA 100 + Pool looks ok but still not crystal. Stains on bottom the brushing wont get up, brownish in color. And some green that comes up with brush, but i cant tell if its algae or pollen. Thanks for all...
  14. M

    Do i have a problem????

    Ive since ordered the TF100 kit, hopefully it will arrive sometime next week. From what little ive read on this forum, its been an enormous help already. THANK YOU!!!!! Ill post results once my new kit arrives. I will say this though. I brought my PH down and the pool has already cleared up...
  15. M

    Do i have a problem????

    Thank you all. Yes i know i need a better test kit. I will look at above and decide. I tested my water today with the kit that came with the pool. Chlorine was 1.5 PH 7.6 - I added some acid yesterday TA 120 Now i got a question about CYA. How would it get so high? Here in FL it seems like i...
  16. M

    Do i have a problem????

    I recently had the water tested a Leslie and here are my results. FAC 0.0 TAC 0.0 CH 450 CYA 250 TA 100 PH 8.0 Pool is looking ok, not crystal but ok. Had a rain storm and lots of pollen seems to have left a slight greenish on bottom but has been going away with brushing and cleaning filter...