Recent content by tone100

Here’s a better picture of the plumbing. Pipe extender is pretty cool. Do I cut off the pipe right below the Tee and above the existing union and then suck it inside the pipe that’s glued into in?Will it hurt the flow?

Im back. I got my new Pentair Intelliflo pump today. The old Sta-Rote pump had the male threads that the union connects to. The new pump requires a new union half to screw into the pump. There is a part number on the union nuts U11-200PS. Is there a union half that will connect to this or do I...

I checked that and it’s it 241v.

Sounds like a good idea. I’ll get one.

Awesome. Thank you again for your help.

Sorry. Don’t why I typed that model number. I meant to ask if the 011056 will work with my Easy Touch.

Will the 011018 work with my Easy Touch? I don’t have anything fancy but I do like the controls. Appreciate all the help.

It’s 8 years old. I’m fine with buying a new one if it’s dead. Just wanted to see if I was missing anything. I see Amazon has the Pentair 011056 for $1,400. Looks to be the cheapest I can get a new one for. Is this model any good?

Ok I did that and it’s still a blank orange screen and doesn’t run.

That’s correct. No SWG or Screenlogic. I put it in service mode and the screen is still blank. Just the orange backlight.

I turned the breakers off for a few minutes and it didn’t change anything. I have a Pentair heater and air blower for the spa connected to the same controller. They both seem to work. I turned off the gas to the heater and told the system to heat the pool and it powered up.