Recent content by soleen

Thank you, for the suggestion, I will look into doing this.

Thank you for your reply, my answers below: When the pump is running full speed filter pressure is 30-35psi Originally, I had 7/16" orifice nozzles installed. However, about two weeks ago I replaced them with smaller ones: 5/16". Before this change, I barely could get any bubbles at all...

Hi everyone, I have a question about my pool setup and would appreciate some advice. My pool was built last year, and I'm experiencing an issue with the spa jets. Two out of the six venturi jets aren't producing bubbles. Here's some additional information: Filter: 60 sq ft DE filter (recently...

Thank you, looks great

This is an amazing idea! Would you mind sharing a photo, so I could show it to my builder? I think, this is exactly, what we are going to be doing, add some decorative tiles around the damaged area.

Thank you, I've replied to your post in that thread. However, I'm still interested in learning: has anyone done temporary water removal from parts of shallow area? If so, what did they do?

BTW, this is a relativly new quartz plaster, the pool was built and plastered last summer.

@ How about carefully smoothing just the part that was chipped, without touching the rest of the surface? Are there other suggestions on what can I do to improve these bubblers? I would use 5.5" faceplates, but I can't find anything larger than 3.5".

Hi everyone, I'm looking for some advice on how to temporarily remove water from my sundeck area. I need to do some repair work on the bubblers, which involves polishing the plaster with a grinder. I'd rather not drain the pool if possible. My sundeck is about 12" deep. Sundeck photos.

As follow up, may be I could just polish this plaster? If so how can I do it without draining pool?

We have two jets on the sundeck that are not very aesthetically pleasing. The plaster around them has been damaged because the pipes were not properly sealed before plastering during the buildingprocess. Is there anything I can do to improve these fittings? Are there large 5" faceplates...