Recent content by ndenunz

I just finished SLAMing and it didn't resolve until I took the decorative plastic strips off the steps. The strips covered up the screws that held the steps in place. The lesson is that you have to expose everything and scrub, scrub, scrub.

Thanks for sharing. Do you get the plans for those chairs from Ana White's website? I built four of them this year to take the place of our plastic chaise lounges that were showing their age. Contrary to your situation, my wife wanted them stained, not painted.

You will be converted to the BBB method if you follow the advice given. Buy lots of bleach, you are going to need it to get your chlorine level up and to maintain it while it does its thing. Spend a couple hours at pool school.

Re: Formula for SWG / Pump Runtime? I, too, can not find the link. The first post has been updated several times. Where exactly is it?

WalMart now sells a 10% liquid chlorine product in the pool section. Unit for unit it is less expensive than their store brand.

bdex: I am in NC

After having issues with the control board for my CPSC-36 SWG, I decided against paying for repairs. Therefore, I have a three year old cell that was working fine before the control panel quit. I hate to have it go to waste so I would be willing to give to anyone that wants it; just pay for...

You should be either adding muriatic acid OR Borax to adjust pH. Acid to lower it and Borax to raise it.

Just had a Compupool unit go bad one month shy of warranty expiration. They would do repairs but it would cost me $75 off the bat plus 66% of what they usually bill. They stated none of the repairs would extend the warranty. Given all the talk on this forum here lately, I decided to stop...

I was about to order one of these but now changed my mind.

CPSC 36 unit purchased a little less than three years ago. There was no power to the board and the fuse needed to be reset. After I did that, there is power to the board but once it powers up to 10% output, it shuts off momentarily then restarts the same cycle again. Anybody experience a...

Re: Fighting with pool all summer -- any advice before I dra Very nice. Thanks for the update.

Anyone out there having trouble finding 20 Mule Team Borax? I have been to two different WalMarts three separate times over the past three weeks and there in none to be had. The space where it is supposed to be is empty. Just my luck?

The reason the bubbles are not being produced is because the LCD and the circuit board are faulty and not sending any current to the cell. No current, no bubbles. The cell is fine.

I have had mine only for about 8 months. After the fix I've not had any problems. It ran at a low level over the winter. Now that the weather is warming up I am in the middle of adjusting its output to keep the chlorine level appropriate.