Recent content by MNPoolboy

Once the fc comes down, I’ll drop the ph & aerate, see if I can get it down some. My last pool hovered around 140.

Retested - 260.

Test kit is brand new TF100

No auto fill. Tap water here is 7.5, TA-250, ch-75

Yes, held at 32.5 overnight & .5cc. Should I work to drop TA?

Hello, I was introduced to TFP about 5 yrs ago, after fighting chemicals & bad advice from the pool company (never heard that story have you!?). I just bought a new house with an old neglected pool last fall, after selling my house (pool was newer & water was great, don’t ask me why....)...

Circuit board replaced, system functioning properly. Thanks again Ping!

Ping, Here are my numbers today after dumping ~25% & refilling. FC - 3.5 PH - 7.6 TA - 170 CH - 310 CYA - 55 Salt - 3200 :p BOR - 30 The sensor is running program A, Firmware 02 11 0A 10. I don't have the small flow adapter card for the sensor (the previous cell/sensor & cord I took out...

Hey Ping, Im still getting the 123 error code and do not get a reading at the board where the swg plugs in. I received my salt water test kit today and here are my numbers: FC - 9 PH - 7.7 TA - 140 CH - 310 CYA - 60 Salt - 4600 Bor - 30 Temp - 89 Would you suggest: replacing about 25% of...

Thanks Ping, I should have my new test kit on Monday and will verify & set the salinity. The 123 code is the only one that flashes. I did briefly get the 145 as I mentioned, but that is the only time I have seen it. The cell came with a new cord and new sensor. The cell/cord & sensor are all...

Hello, I have Janday Aquapure 1400. I replaced the salt cell (& cord) about a week ago, which I thought was bad. I am now getting an error code "123". I have done the main circuit board tests (https://premium.zodiacpoolsystems.com/~/media/5e517452be9c402b9aef35ce3d54eb51.pdf) and receive...

Hey Ping, I have the 1400 model. I checked the pins and also tested the board where the green & blk/wht wires connect (cord from the cell) and only get 0.0. All other board tests pass. I did just receive a 145 error code (reading the salt at 5300, I normally keep the salt at 3200-3400 and...

Thanks Ping, I haven't seen any other codes that flash other than 123. The cell/cord/sensor is only about a week old. I will double check to make sure the pins are tight. I don't believe I am getting any voltage to the cell though.