We are on a well and have noticed some rust spotting in our pool and have been removing with tablets. We have an auto fill from our well that is introducing rust. Could I put a tablet in the autofill bucket each week to prevent the spots?
Brushing pool the other day and I found small spots (about an inch) that are rust colored. We have an autofill from our well that has red iron. Any advice on treatment for the spots as well as a continual way to prevent them from returning?
Wanted to update with some success in not having to drain my pool 40% as recommend to balance salt! My salt reading according to our local store was actually 6500! I drained pool 12 inches (18,000 gallon). I put two hoses to begin refilling right in front of my two main drains and secured them...
Thanks guys for the replies. I was wondering if I diluted the water going into the SWG by placing the hose in the skimmer (which I would close main drain and leave this as only return to the pump). If this flow of partial pool water partial hose water would allow the swg to convert. I was...
Ended up with way to much salt in our pool 5800 according to our automation the store said 6500. If I were to open only the skimmer add a garden water hose in it and super chlorinate would that work to lower the level to produce again? Could this process harm anything? We are in Fl with a high...
Led deck jets installed and bubbler chipped out
They really struggled with bubbler in addition to having to chip it out the shotcrete caught a bunch of the wire inside the concrete as well. Hope this will still function good.
Deck jets seemed to be pretty labor intensive to set as...
Ok just wanted to make sure. We already have price set for the two colors, but right now on that lip of sun shelf there is a line of tile what we are afraid may have our pool looking too busy. Was wondering if there were any other methods to have these two finishes be separate without having the...
No, wasn't sure if any pool buyers had this done and had any suggestions on how it was done. Should I check forum rules, am I not suppose to ask questions like this?
Is it possible? Shotcrete was in last week and our pool bubbler is about 3 ft off center. We suggested adding another to offset the unsymmetrical bubbler. What would be the process for this so I could maybe pass it along?
Thanks,
Mark